بیل مکانیکی ریلی Hitachi EX 100M, Leppävirta برای فروش در مزایده

Old Hitachi EX 100M excavator. A popular, handy machine. Meter reading 6,850 hours; it is not known for certain whether this is correct. Model year 2003 is stated on the plate, but Rotator has not verified the accuracy of the information. If desired, you can ask Rotator for information using the serial number on the plate before placing a binding bid, including whether they have any history or service records.Equipment:Tilting bladeNTP10 bucketSupport skisWide tracks, 980 mm. According to the previous owner, the pump has been opened and wear parts replaced, but there is no information on whether Rotator Oy or someone else repaired the pump. Apparently some work has been done, as hoses etc. have been marked. The pressure sensor is new, and the mechanic replaced some new solenoids. The pump pressures were briefly checked and appeared to be correct at 350 bar. There is no other history information. NOTE: This is an old machine. It is best to arrange a separate viewing and allow time to inspect it. Please test-drive and examine the machine before placing a binding bid. Delivery can be arranged quickly by separate agreement.
Used older machine, with wear, play, dents, lights not working and other issues. May be an old machine; condition as shown in the pictures/video and according to the equipment. Fast travel (hare mode) did not work; the fault has not had time to be investigated. The model year has not been checked. It is not known whether the hour meter works. No service history is available, nor is it known when it was last serviced. The machine’s computer circuit board has been opened, and 2 or 3 burnt diodes were found that control the pump; a new diode has been soldered in. However, the pump control does not work perfectly: slow travel works, but fast travel could not be selected with the button during the test drive. The machine may be made faster once the cause is determined. The pump is probably not faulty, as the pressures were measured at approximately 350 bar. The circuit board needs to be inspected for a cold solder joint; a sensor may still be faulty, or a wire connection may be loose, or a sensor may not be working. The cause has not been established. A technician familiar with Hitachi machines is required to investigate the cause; determining this remains the buyer’s responsibility. The bidder/buyer must service the machine. A major service is recommended, as the history is unknown, along with any repairs they deem necessary.
registrationStatus: 3
inspectionStatus: 3
vehicleInsurance: 3
drive: 4
isYearModelUnknown
ceMarkingStatus